Tache convert drawing to dxf

PDM Generality
1

Hello 

 

for the automated EPDM tasks I have an automatic conversion from MEP to pdf

But I'd like other solutions like DXF.

So I made  a copy/paste of a task convert drawong to pdf 

and I changed the file output but since I have two sheets in the drawing, the DXF only outputs one page 

 Is there a single exit page (i.e. the first sheet)?

Can I choose to make as many DXf files as sheets?

Do you need a script?

 

bàv,

2

Hello

I would say that it depends on the configuration of the SolidWorks that will do the conversion. As EPDM uses SolidWorks.

So you can look at the recording options. When you have a drawing in SW, File/Save-As/dxf/Options: this is the last paragraph.

3

Hello

This is not adjustable in your ePDM task?

For me I can see attached picture!

@+

 

 

 


convert.jpg
1 Like
4

I had a problem with the workflow which actually has two paths when approving and in fact now I put the task of creating DXF in both paths and it works.

Two page two DXF

so I may have seen badly but now it's ok 

5

And it's certainly at the level of solidworks that it chooses if you release a page for everything or separate DXF pages...