By selecting "segment angle" and setting it to the minimum (5°) I get to 18mm....
We're getting closer!
And by clicking on Lg of the segment, I can't type + 4mm so I end up with folds of 3.8... too small. :/
With the number of folds?
2 Likes
With the number of folds, it doesn't work either...
On the other hand........ I SUCCEEDED =)
I chose "straight tolerance", I set it to 0.1mm and I lowered my bending radius to 1.6 for 2 mm thick.
I went through a transition fold =)
3 Likes
Oh well! Have a good weekend Bart!
2 Likes
Additional info:
I had drawn my complete profile. And that's where Sw didn't understand.
I just had to draw the arc of the circle, so I can choose the length of the segment, to then add my edge folds....
There you go!
Thank you all! =)
transition.png
2 Likes
So, just to understand, your segment length of 10 is to the neutral fiber?
1 Like
Do you know why in a sketch, you can't make a polygon of more than 40 sides?
Probably a limit made by the designer?
1 Like
In any case, it's written in black and white in the help up to the 2016 version: 3 to 40 sides. http://help.solidworks.com/2016/French/SolidWorks/sldworks/HIDD_DVE_SKETCH_POLYGON.htm
Note, already with 40 sides, we are not far from unmanageable.
2 Likes
Well, in any case, it's marked in the help... Thank you Benoit;)
2 Likes