Memory hole on the properties of a sub-ASM

3D Design Assembly
21

Thank you for the property.
By the way Where is the property form?

22

Good news, everything works thanks to your good information. It's simple when you go to the right menu :grinning:

Do you have a tip for the material which in the case of this sub-ASM is composed of several materials. What to wear?
If I don't fill in this value, it puts me in an error in the MEP.

1 Like
23

Simply create the corresponding property (here: Material), but without specifying any value. The error will disappear.
But it is more qualitative to put " -" as a value to indicate that it is not an oversight but the character "not applicable" in this case.

3 Likes
24

Normally in assemblies there are no visible materials. The materials will be entered in the nomenclature.
Not advisable to force the material.

1 Like
25

Thank you @Le_Bidule

The problem is that he puts me wrong on the matter with the suggestion of @Silver_Surfer . Do you have a tip? other than creating a plan template without the $PRPSHEET area: " Material "

Note that the @Silver_Surfer trick does not work for the moment.

26

@Silver_Surfer Your recommendation doesn't work, sorry! What did I do wrong?

27

image
image1920×1152 222 KB

28

Mea Culpa (zozo in zombie mode)

My mistake is the dumbest of the week!
Instead of selecting material from the list, I type materials with an X. So obviously SW doesn't like it...
After correction it works very well :wink:

Thank you for your patience @Silver_Surfer

3 Likes