Hello
I'm new to SW and I'm having the following problem:
I imported a step that I modified.
The units of the sketches created are always in meters instead of being in millimeters as the default in my other created parts.
However, the settings at the bottom right are indeed in MMGS.
Do you have any idea how to fix this?
Thank you.
Screenshot below;)
capture_ecran.jpg
Double click on the dimension to edit it. Then type the value in mm appending mm at the end.
like R 6mm, 100mm
2 Likes
Hi thanks for your answer.
Actually I open again the part this morning and it change by itself to mm.
soring
4
Hello
The WWTP was probably saved in unit meter. Just set this in the options / properties of the document (step file open) as below.
Check MMGS
