Hello Solidworksians.
In some sheet metal parts, when I take the values from the welded parts list and want to insert them directly into the part properties, SW can't put the values...
There must be a parameter in the document properties of the part to be modified but I don't know which one.
Anyone have an idea???
We have a model of sheet metal part in which it works very well but not here
Thank you for your help
Regards
Serge
Hello
Are you missing quotation marks at the end of line 2?
No.
It's a copy-paste of the dimension line I have in the welded parts list that works perfectly but not at the level I put it back in.
I also think that a quotation mark is missing to close the command.
It may not have been taken during the copy.
Hello
I think there are some parameters missing. I tested on a sheet metal and it's rather formatted like this:
"SW-Welded-Parts List tôlerie@@@Article Welded-Parts List1@xxx.SLDPRT" x "SW-Welded-Parts tôle@@Sidewall Width@Article 1@xxx.SLDPRT" x "SW-tôle@@ Sidewall Area@Article-Welded-Parts-List1@xxx.SLDPRT"
Appears to be missing the item list ID of the welded parts.
Hello
This problem has been posted several times, I remember this post ,
I had tried a lot of approaches but in vain
On the other hand, it is possible to concatenate in a nomenclature
What's weird is that when you start from the sheet metal part model that we made, it works very well
Hello
Re-read your line mapping, you will see that there are missing parameters on your initial capture of the problem. @@@xxx@yyy.sldprt
Hello
I do it like this to link the ribs: here is a link to one of my tutorials
https://www.lynkoa.com/contenu/comment-lier-les-côtes-de-la-3d-dune-pièce-de-tolerie-aux-propriétés-personnalisées-0
