Personalized windshield

Out of category
27

ba send it to me the image at home it doesn't work.

2 Likes
28

I'll send you my images as soon as my network is repaired.

 

Sorry!

29

Finally repaired!!

 

Here are the pictures!

 

That's what I understood???


avant_bulle.png
30

Here is the 2nd


apres_bulle.png
31

And finally the third !!

 

Happy reading!


detail_bulle.png
32

@bart: After the 2nd image, did you have it rebuilt? And if you redevelop the BOM display, the bubble info remains?

 

 

33

@Bart

 

Can you do the test by putting 2 parts in the assembly and putting the PWR on the part and not the assembly. This is the only difference that persists with the image of @jsourd!

34

Hi all!

 

Here is the last test!!

 

I did it with an assembly, I didn't even need to rebuild, everything follows automatically

 

No problem!

 

I attach the photo.

 

 


bullage_auto.png
35

I don't understand, it doesn't work for me... See attached image.


capture9.png
1 Like
36

@jsourd: can you send your example in zip (assembly of 2 cubes + MEP)?

 

@bart will be able to try your model...

37

Attached files


test.rar
1 Like
38

I took back your files, (I hadn't seen that there was an answer...)

 

Indeed, there is a small problem on your mep.

 

So I recreated it with my background.

 

Here's what I get


nomenclature.png
39

So I advise you to redo your mep by removing the old one.

 

Sometimes Solidworks bugs a little and when restarting the mep, it passes. What for? I don't know, but it happens.

 

In any case, with your plays, I succeeded. And I haven't touched anything about your config.

 

Good luck in any case.

 

And don't hesitate to come back!

40

If it works for @bart, the problem is probably with your drawing or BOM template !

41

@bart, can you send me your drawing that I'm trying on my side to see if it's my MEP or my name that poses pb...

1 Like
42

Here is your assembly with my mep!

 

Tell me what it says about you!


test.rar
1 Like
43

Ok thank you Bart, indeed it doesn't work.

 

I did the manip again, you will find attached the 3 images of the setting up of the bubble:

 

Capture 1 balloon with article number: the balloon symbol appears in the name.

Capture 2 Changing the bubbles to custom property: the bubble symbol appears in the name.

Capture 3 Blueprint update: The bubble symbol disappears.

(image in 3 messages).

 

So a priori no solution for this point. tampi we close the subject.

 

Thank you in any case for looking at my pb.

 

See you soon for new problems I hope easier to solve...; -)


capture1.png
4 Likes
44

Capture 2


capture2.png
2 Likes
45

Capture 3


capture3.png
2 Likes
46

If the Lynkoa community has not been enough, and in particular the service of @bart, call the hotline...