Decal

Good evening
I have a problem with etiquette. I don't use it much and I must have forgotten but impossible to get out of it. I put a transfer on the cylindrical side and it appears on both sides, one of which is upside down; As if on the " projected curve" tool, the bidirectional option was always checked. I put more explanations in the attachment. It's very annoying, I feel stupid.

Thanks in advance
décalque.pdf issue (385.2 KB)

Hi Pierre,

I see that you select an assembly, if you select by the part you have the label option?
image

1 Like

Hello Pierre,
I'm not a pro at decal representation.
But I may have found a solution, which is to make two decals with the same modification, which will allow the modifications to be in the same direction. (SW2022SP4).
Here's my screenshot and the part to check if it fits.
@+.
AR.


Item1.SLDPRT (304.7 KB)

Apply Decal - 2022 - SOLIDWORKS Help
→ "It is recommended to apply a decal to a part rather than to an assembly. In a room, you control the faces on which the decal is applied. In an assembly, it is not possible to select specific faces. »

4 Likes

Thank you, indeed my problems came from the fact that for some reason I stubbornly applied this decal to the assembly. In terms of the play, I find what I knew.
Thank you again and have a good day

1 Like