Automatic thread drawing representation

Hi all
I'm using SolidWorks 2022 SP5 and I have a question regarding the thread representation in the drawing.
I created a component with 2 taps:

  • 1x Drilling wizard, tapped holes
  • 1x Thread performance on outer diameter

When I create a drawing of the part, all the tapping is visible on the drawing by default.
But if I put this part in an assembly and I draw the assembly, no tapping is visible.
So at the moment, on each assembly drawing, I need to insert → model object and select the thread annotations.
Can I change the behavior of the assembly drawing to automatically import thread annotations as I would for a part drawing?
Did I miss a config point in a model somewhere?
Thank you in advance for your help
Dan Steinmann

1 Like

Hello Dan_Steinman,
I know this problem of the display of a tapped hole that does not appear in MEPs, which sometimes appears, so here is a picture: (Check this too =>


) and that too =>

1->


2->
2023-08-21_115149
3->to check and uncheck for the thin stroke of the tap" checked without then closed, then reopen the function and re-check the option show the thread stroke =>
2023-08-21_115619
4=>Then the result on MEP =>
2023-08-21_115656

Find attached a small tutorial to solve this little problem.
=>

https://mycad.visiativ.com/en/contenu/affichage-trait-fin-dun-taraudage-sur-mep-sw-2022-sp4-cela-fonctionne-aussi-sur-les-autres-v
And to complete a small PDF on this subject=>
2023 SolidWorks - Upgrading héritées.pdf Thread Representations (120.3 KB)

Here's hoping that this will help you solve your problem.

@+.
AR.

1 Like